Water Purification

Mineral Water Plant

A mineral water plant treats source water through selected filtration, membrane and disinfection stages before it enters the required storage or filling process.

  • Source-water analysis
  • RO and filtration
  • Final disinfection
  • Mineral water bottling line with stainless-steel processing equipment

    Pure Waters

    Design • Fabrication • Installation • Maintenance

    Source-water assessment

    The treatment plan starts with laboratory testing of the incoming water. Groundwater or brackish water may contain dissolved solids, hardness, iron, turbidity, colour, odour or microbiological contamination.

    The process is selected to address the measured characteristics rather than relying on a single standard plant.

    Typical purification sequence

    1. Store and feed the raw water at a controlled rate.
    2. Remove suspended solids through sand or multimedia filtration.
    3. Use activated carbon where taste, odour, chlorine or selected organic matter must be reduced.
    4. Apply softening, micron filtration or antiscalant dosing as required.
    5. Use reverse osmosis or another membrane stage for dissolved-solids reduction.
    6. Disinfect and transfer the treated water to a hygienic storage or filling system.

    Treatment technologies

    • Pressure-sand and multimedia filtration
    • Activated-carbon filtration
    • Iron removal and water softening where required
    • Micron cartridge filtration
    • Reverse osmosis
    • Ultraviolet treatment
    • Ozone or other final disinfection when specified

    Plant arrangement and operation

    The plant layout should separate raw-water, treatment and finished-water areas while allowing access for cleaning and maintenance. Pumps, vessels, membranes, instruments and storage components are sized around daily output and peak operating demand.

    Discuss your mineral water plant requirement

    Share the water source, flow, treatment objective and site conditions with Pure Waters.